Many other instruments are supported. Please contact UTEX support for information about other legacy devices.

Acquisition Logic:

The recommended drivers for Winspect 6.x are AL_NET_1_2_102

These may be downloaded from the Winspect support page:

http://www.utex.com/webapps/utexsupport.nsf/wPages/MSZI-7AXT3L2231?Open

Links are provided on this page for the required Microsoft Dot-Net utilities.

Winspect 6.x supports the Galil DMC family of motion controllers, including the DMC-20x0 series, the 17x0 series, and the DMC 18x0 series.

Galil drivers up to version 7 are supported.

The DMC Setup program is required, to configure the Galil motion controller

All driver files and sopftware utilities plus additional support information are available at the Galil website:

http://www.galilmc.com/support/software-downloads.php

Galil traditional drivers and the new Galil Tools drivers are supported in Winspect 7.x and higher

Gage Compuscope digitizers are supported in Winspect 6.x, using the ver. 3.6 or 4.2 drivers

For Windows 2000 and Windows XP, please use the drivers version 4.2

For Windows 98, ME and Windows NT, please use the drivers version 3.6

These can both downloaded form the Gage website

http://www.gage-applied.com/support/secure/legacydrivers.htm

Winspect 6.x supports National Instruments NI-DAQ drives up to version 7.4

Ni-DAQmx devices are not suported in Winspect 6.x

National Instruments Ni-DAQ and NI-DAQ MX devices are supported in both Winspect 7.x and InspectionWare 7.x products.

Follow the link below to download NI-DAQ drivers 7.4.4 form the National Instruments support website.

http://joule.ni.com/nidu/cds/view/p/id/570/lang/en