» Support » Knowledge Base » Hardware Support
How to perform a Master Reset on UT320 and UT340 Instruments
UT320 and UT340 instruments can be returned to factory default specifications by performing a master reset. This document describes the procedure for each type of instrument.

A master reset should only be required if the instrument becomes unresponsive. This can be caused by failure of the memory back-up battery after long storage periods.

Hide details for UT320 InstrumentUT320 Instrument

UT320 units shipped or retrofitted after 2005/07/20 are equipped with a master reset button on the back panel.

To perform a Master Reset on a UT320 instrument:


    1. Turn OFF the instrument using the rear panel power switch

    2. Locate the master reset button on the rear panel opposite the main power switch

    3. Press and hold the reset button for at least 6 seconds.

    4. Turn on the instrument's main power using the rear panel power switch

    5. Press the power button on the front panel to restart the instrument


Hide details for UT340 InstrumentUT340 Instrument

To perform a Master Reset on a UT340 instrument:


    1. Turn off the instrument using the rear panel power switch. Wait at least 10 seconds.

    2. While holding the ‘F1’ key on the front panel, turn on the rear panel power switch.

    3. Continue holding the ‘F1’ key for approximately 3 seconds.

    4. Release the ‘F1’ key and press the ‘6’ key on the numeric keypad.

    5. After approximately 8 seconds, the instrument will beep twice and the display will come up in pulser mode with all variables set to their minimum values.

    6. If the ‘F1’ key is not held for at least 2 seconds, the instrument will continue with a normal power-up sequence.

    7. If the ‘6’ key is not pressed within 3.5 seconds after releasing F1, or if any other key is pressed, the instrument will continue with a normal power-up sequence.


These procedures are also described in the UT320/UT340 Operations Manual. Click the link in Related Resources below.

Again, the unit should perform a normal power up sequence with the LCD ON. You will hear a long beep.


Related Resources
UT320 and 340 Pulser Receiver Manual Rev 1.2
This page contains a PDF version of the product manual for UT3xx series Pulser Receivers.
» Support » Product Documentation » Manuals
Document Reference
Categories
Instruments
UT3xx Pulser Receivers 
Product Version/Model
UT320, UT340 
Document Number
DSEO-7VVSJR5534
Published
09/14/2009 Rev: 1.0
  Print Email page Share